Air Brake Leak Test Calculator
Put in two gauge readings and the minutes you timed. See if the truck passes the CDL handbook limits.
By Alan Bradshaw (author page). Sources read November 21, 2026.
Every CDL driver learns a leak test for the air brakes. Most of us do it by watching the needle and guessing. This page does the math. Put in what the gauge read at the start and the end, how long you timed it, and whether you were holding the foot brake.
Limits from the Texas DPS CDL handbook, Section 5 (DL-7C). The calculator divides the drop by the minutes you timed.
The Limits The Calculator Uses
| Test | Single Vehicle | Combination |
|---|---|---|
| Engine off, parking brake released | Less than 2 psi a minute | Less than 3 psi a minute |
| Engine off, foot brake fully applied, after the gauge settles | No more than 3 psi a minute | No more than 4 psi a minute |
How To Run It So The Number Means Something
- Build air to governor cut out. The handbook says that is usually about 120 to 140 psi, often around 125. Know your own truck's number.
- Shut the engine off. Chock the wheels if you need to.
- Release the parking brake. On a combination, push in the tractor protection valve too.
- For the released test, just time the needle for one minute.
- For the applied test, push the foot brake all the way down. Wait for the needle to settle after the first drop, then time one full minute.
The first drop when you step on the pedal is normal. That is air filling the brake chambers. Only the slow fall after it counts.
Fail? Where To Look First
A leak that only shows with the pedal down is on the service side, so think chambers, the treadle valve and the service lines. A leak with the brakes released is on the supply side. Glad hand seals, fittings at the tanks and lines that rubbed on the frame are common. Read the full daily air check next.